Odrdzewiacz 250ml

That exhaust didn't always look like that.

Somewhere under the rust is the pipe you actually paid for, and Rust Remover brings it back. Brush the gel on, give it 10-15 minutes, wipe it off. That's genuinely it. No wire wheel, no elbow grease, no weekend lost to a bolt that won't budge.

Why this one's satisfying to use:
It's a gel, not a spray, so it stays put on vertical surfaces and downpipes instead of dripping everywhere. And because it's non-corrosive, no hydrochloric acid, no bleach, you can leave stubborn rust to soak longer without it eating into the metal underneath.

Where it earns its keep:

• 2-stroke/4-stroke exhausts and downpipes gone dull and orange
• Nuts, bolts and fixings seized up with rust
• Chrome and steel that's lost its shine
• Any small metal part you'd rather revive than replace

How to use it:
Clean the area first with a Motoverde Bike Wash, brush Rust Remover on evenly, leave for 5-10 minutes, then wipe off with a damp cloth. For nuts and bolts, just drop them in a beaker and let them soak. Repeat if needed, some jobs need a second pass, and that's fine.

It also leaves behind a corrosion inhibitor, so the part you just brought back doesn't start rusting again next week.

How long does it actually take to work?
Most rust lifts in 5-10 minutes. Heavily rusted parts might need a second application or a longer soak.

Will it damage chrome or my exhaust underneath?
No, unlike acid or bleach-based removers, it's non-corrosive, so it's safe on chrome, steel and other sensitive metals.

Can I use it on 4-stroke exhausts, or is it just for 2-strokes?
Yes, while it's especially popular for reviving 2-stroke pipes, it works just as well on 4-stroke exhausts, downpipes and headers.

Is it safe on stainless steel?
Yes, stainless steel is one of the metals it's formulated to be safe on, along with chrome and standard steel.

Can I use it on small parts like nuts and bolts?
Yes, drop them into a beaker of Rust Remover and let them soak for 5-15 minutes, then rinse and dry.

Does it stop the rust coming back?
It leaves behind a corrosion inhibitor after use, giving the metal extra protection against rust returning.

What should I use afterwards to keep it looking good?
Once the part is clean and dry, follow up with a protectant like Motoverde After Shine, it adds a protective layer that helps repel moisture and dirt, so the rust has a harder time coming back.

Do I need to clean the part first?
Yes, give the area a wash first so the gel can get straight to the rust instead of working through built-up grime.

Is it a spray or a gel?
It's a brush-on gel, which is exactly why it works well on vertical surfaces like downpipes, it stays put instead of running off.

Danger: Causes sever skin burns and eye damage. Keep out of the reach of children. Do not breathe dust/fumes/gas/mist/vapours/spray. Wear protective gloves/protective clothing/eye & face protection. IF SWALLOWED: rinse mouth. DO NOT induce vomiting. IF ON SKIN (or hair): take off immediately all contaminated clothing. Rinse skin with water/shower. IF INHALED: remove person to fresh air and keep comfortable for breathing.

Keep out of reach of children. Store in a cool, dry place away from direct sunlight.

YOU MUST BE 18 YEARS OLD TO PURCHASE THIS PRODUCT. BY PURCHASING THIS PRODUCT YOU ARE AGREEING THAT YOU ARE OVER 18 YEARS OLD.